Windshield wipers, rubber refills that might fit Toyota Previa

 Video show how I did, and then more options below.

--------------------  -----------

Maybe you can find: Genuine Toyota (85221-YZZB3-TM) Wiper Blade Refill

Brand: Toyota

Otherwise check out diffrent alternatives down below. I tell you what I did.

Original is 28" long

But has spray bar which makes it a bit harder because of washer nozzle and hoses. 

https://www.biltema.se/bil---mc/bilreservdelar/torkarutrustning/torkarblad/torkarblad-700mm-28-2000034120

https://www.biltema.se/bil---mc/bilreservdelar/torkarutrustning/torkarblad/torkarblad-600mm-24-2000029631

Anco W28R work on 95's...I don't remember if there is a difference between them and earlier models so you may have to research that aspect...

--------------------------  -----------------

https://www.ebay.com/itm/301827840348

"They are 28 " long and 8 mm wide. The NAPA part number is 6-2800. They aren't easy to replace.

The other thing I have done in the past when I could not find a 28" blade is use two 14" blades or a 13" and a 15". It's not ideal but it works when you have to do it. Better than nothing or using totally worn out wiper blades.

Waxing the windshield or using Rain-X also helps a lot."

https://www.toyotanation.com/threads/wiper-blade-refills-help-help.315020/

Use W40 or PTFE or something that makes it slide in easier.

----------------------------  ---------------

What did I do?

I bougt general rubber from Amazon.se

Great tips from Scotty, change servo fluid and clean wipers with alcohol and water

Good tips from Scotty Kilmer. Change power steering fluid reservoir the easy way.

He is using a Turkey baster. In Sweden we can probably use Blåsbälg/Bollspruta/Hävertpump


https://www.autozone.com/repairguides/Toyota-Previa-1991-1997-Repair-Information/STEERING/Power-Steering-Gear/_/P-0900c1528008a637

Windshield wiper replacement, Toyota Previa using Bosch

Stan Buckalew has found a windshield wiper replacement for the Previa:

"Finally got a windshield wiper replacement. Just bought the brand shown and changed blades. There's one end to unclamp by squeezing the rubber into the clamp and then sliding it out. Slides into frame same way"

Thanks Stan! Might come in handy when it's time to change ! :-)

Pictures from Stan:

------------------  ---------------
Another solution from Micah Foti:
" I just drilled out the rivets holding the old wiper blades on and put new ones on with bolts"

Picture showing bolt and nut, from Micah Foti. Thanks for the tip!

 

Micah Foti  "I just removed my old wipers from the arms (they're riveted on), drilled out the small hole to match the size of the big hole, then you can just use a bolt/nut and install any wiper blade you buy anywhere."

 

 

 

 

 Somebody has used standard 26" and slide in the new ones.

 

Photo: Parker Kropenick

"I got these off of eBay I believe. Pretty sure the blades are the oem ones. They are just inserts that snap on the little clips. My van is a 91 btw. If you can't see because of the glare it says "W-28R" made by anco." - Parker Kropenick